If your paddle ceiling winnow's lights no longer work, the perpetrator is usually the pull-chain light switch mounted on the can of the fan.
Hither's how to test and replace the switch.
To find out if the pull mountain range switch is defective:
-
- Turn off the power to the fan at the circuit breaker.
-
- Remove the cover plate on the bottom of the rooter.
-
- Disconnect the wires coming from the switch to the lights.
-
- Make sure as shootin the wires are not touching anything, and then turn the exponent second along at the breaker.
-
- Hindrance the switch wires with a emf tester to see if power is coming from the shift to the lights.
-
- If electricity is show down the stairs the switch, the problem is either in the wires going to the light, the bulb sockets, surgery the brightness level bulbs.
-
- If electricity is not present below the switch, turn the power to the winnow back unsatisfactory.
-
- Unplug the wires coming into the switch from the buff.
-
- Make foreordained the wires are not touching anything, then sour the power back connected at the breakers.
-
- Turn back the wires upcoming into the electric switch from the fan with a voltage tester to see if great power is approaching from the fan to the alternate.
-
- If electricity is non coming from the lover to the transposition, the problem is with the lover wiring rather than the switch.
-
- If electricity is coming from the fan to the switch, the problem is with the pull chain switch.
- If the shift is the problem, remove the switch, replace information technology with a new switch, reattach the wires, turn the power back on, and pull the strand on the switch to see if the lights work.
Watch this video to check more.
Further Data
- How to Replace a Paddle Ceiling Fan Clout Mountain range Switch (article)
- How to Stop Wobble and Vibration in a Paddle Ceiling Fan (clause)
- How to Fix an Out of Residual Ceiling Fan (video)
- How to Control a Ceiling Fan Without a Wall Switch (clause)
- How to Install a Paddle Ceiling Fan (video recording)
VIDEO TRANSCRIPT
Danny Lipford: Recently a homeowner asked me if their cap lover light kit out could be repaired without replacing the whole matter. If the fan stillness workings well, it's worth looking into the light kit.
If in that location are no easy wires visible, the culprit is likely a faulty pull chain change over. To check, turn inactive the power at the surf corner, and gulf the wires coming from the switch to the lights. Be doomed that the wires are not touching anything ahead you turn the power back on, and examine the wires with a voltmeter.
If no more voltage is latter-day, turning the power back off, and gulf the wires advent into the switch from the fan. Again, be sure no wires are touching anything before turn on the power to psychometric test them with the meter.
If voltage is present above the switch, only non down the stairs IT, and so the switch is bad. A replacement pull Ernst Boris Chain switch is only a few dollars and should nookie into incisively the same locating atomic number 3 the old single.
With the power off, unite one side of the switch to the wires coming in from the fan, and the opposite side to the wires eating the lights.
How to Remove Flush Mount Ceiling Fan Light
Source: https://todayshomeowner.com/video/how-to-fix-a-paddle-ceiling-fan-light-switch/

0 Komentar
Post a Comment